mr mac

Member

• Oct 9, 2015

• #1

Morning.

I have bad clonking when turning under load and believe it's the driver side CV JOINT.

Now I'm looking at what parts I need to order as not done this before

Do I just get CV and gaskets with grease or do I need half shaft too?


Thanks

Ian

 

666 george

Well-Known Member

• Oct 9, 2015

• #2

Have you tried putting some grease on it to start with.

 

jamesmartin

Well-Known Member

• Oct 9, 2015

• #3

cv and gaskets ( driven member and stub axle)and one shot sachet if swivel is filled with it,cv will tap off half shaft , you need a screw driver or 2 to hold clip tight against half shaft when refitting, if you undo top swivel pine to remove brake pipe bracket place a jack or support lower pin first so as not to disturb swivel seal

 

Kwakerman

Well-Known Member

• Oct 9, 2015

• #4

New tab washer for hub nut, grease seal for inner wheel bearing, and caliper bolts wouldn't go amiss.