tweedandbriar

Active Member
Hi,

I am changing the seals and washer at the weekend. I watched this really good and comprehensive video and note that he cranks the engine a little but doesn't say why other than to see the rockers rise and fall.... Can someone explain why he does this please?

Injector Seals and Washers

Thanks!
 
*** Sorted ***

Found this, just in case anyone searches and is looking for the same:

Workshop - Injector Removal / Seal and Washer Replacement.

Rotate the engine until No1 Cylinder is at TDC (top dead centre). No1 is the pulley end of the engine. There is a couple of ways to know when No 1 is at TDC, you can either watch the rocker shaft lobes and continue to rotate until No 1 stops "lifting" or if you look at the back of the camshaft pulley (where the timing chain is) you will see a slot or key way cut out of the back.......picture arrowed below....
 

Similar threads