B

biggerbinns

Member
Hi, my 1999 p38 has flashed up a LH indicator failure and believe a RH side light failure but it hasnt popped up again since I have run it up on the drive with the lights on.
I am going on a long run with it at the end of the week and want to nip any poblems in the bud before I go.
Any suggestions apart from waiting untill it stops altogether?

Cheers

Mike
 
Common symptoms of BECM failure is either phantom bulb failure messages or more often the rear wiper not working. Be wary of buying BECM's from Egay as they will have to be rewritten to suit your car, plus you will need the Lockset Code (Approx. 13 digits) for your vehicle. Your LR Dealer can get this for you but will need sight of the Registration Document/proof of ownership and possibly I.D. Provided the BECM is unlocked, it can be recoded. Also,be sure that the BECM matches the car specification as there are "High" & "Low" specs. New BECM will cost around £750 fitted by a good Independant service company.
 
Cheers for your reply, I hope to find somthing wrong with the bulbs but I am not confident as it is not constant.
I will look at the bulbs later as I have not been near the vehicle to do that yet.
If the bulbs are all in order and without replacing the BECM can this problem be dealt with by use of the landrover diagnostic kit?

Cheers
 
Hi all

I now get the RH side bulb problem but checked all the lights and they all work fine. Comes on as soon as the key goes in. Could it be the sensor or is it likely the BECM?

IF this is a problem with the BECM is the box fixable or does it require a new one?

Cheers

Adam

Also have an intermittent alarm fault that seems to go away after driving some distance which would indicate battery, i guess. Don't know if it is related or if it is just a loose connection?
 
Right, did a long drive to Scotland today and found that all the lights on the vehicle work fine but it will pop up on the dash that they have all failed.
As the day has gone on these warnings have dissapered but not sure yet if this is for good.

Any further suggestions than to just leave it alone?

Mike
 
Its probably one or more of the MOSFET on the power board (the upper section board of the BeCM) that has failed. IT IS possible to buy a second hand BeCM on eBay and swap the power boards over but its a bit of an unknown as you dont know what the state of the replacement power board is.

-Wills :)
 
HI, the warnings have not come back and believe it is from having a good run and the battery getting a bit more of a charge.
Heard that they suffer when the batterys get a bit low on juice and do funny things, did'nt really believe it myself but it must be right.
Will be keeping it on trickle charge when it's not been used often or when it'd doing short journeys.

Hope that helps some of you to save a few quid and hassle.
 
hi folks
i have had 2 becem's on my 1997 4.6 hse in the past 4 months...the first one was supplied and fitted by a well know guy on this site and i was told he only fits genuine BRAND NEW BECEM from land rover(i have now found out since there is no such thing as a brand new becem fromland rover any more as there all reconitioned units)this unit lasted 3 months,but started playing up 2 days after it was fitted...to cut a very long story short it went to lockout and shut itself down...after doing a quick search on ebay on friday afternoon a found a guy local to me...i called him and he came out the very next day...he had my range rove up and running again in a couple of hours....nothing was to much trouble for him and i can not recommend this chap highly enough...my range rover is up and running and sounds better than it ever did....so nice to hear those janspeed pipes again...his name is doug of MODULE DIAGNOSTICS...got a becem fault on your land rover give him a ring...you will be so pleased you did...turst me i learnt the hard way
 
mybigfattd5 said:
hi folks
i have had 2 becem's on my 1997 4.6 hse in the past 4 months...the first one was supplied and fitted by a well know guy on this site and i was told he only fits genuine BRAND NEW BECEM from land rover(i have now found out since there is no such thing as a brand new becem fromland rover any more as there all reconitioned units)this unit lasted 3 months,but started playing up 2 days after it was fitted...to cut a very long story short it went to lockout and shut itself down...after doing a quick search on ebay on friday afternoon a found a guy local to me...i called him and he came out the very next day...he had my range rove up and running again in a couple of hours....nothing was to much trouble for him and i can not recommend this chap highly enough...my range rover is up and running and sounds better than it ever did....so nice to hear those janspeed pipes again...his name is doug of MODULE DIAGNOSTICS...got a becem fault on your land rover give him a ring...you will be so pleased you did...turst me i learnt the hard way
Click to expand...

Hi mate,
where is this guy based? Module diagnostics. is this his ebay ID? I tried a search but found nothing. email me please anorakmark@gmail.com
Thanks.
 
biggerbinns said:
Right, did a long drive to Scotland today and found that all the lights on the vehicle work fine but it will pop up on the dash that they have all failed.
As the day has gone on these warnings have dissapered but not sure yet if this is for good.

Any further suggestions than to just leave it alone?

Mike
Click to expand...


Condensation inside the BECM from wet carpets can cause funny things to happen. A long run may have generated enough heat to dry things out. Check for we carpet.:)
 
You must log in or register to reply here.

Similar threads

A
P38 2000 4.6 Thor vogue RHD HVAC issue
Replies
4
Views
273
alex230718
A
cornishboater
P38A HEVAC
2
Replies
35
Views
2K
pwood999
pwood999
B
Is this a starter relay problem
Replies
9
Views
819
Nig
Nig
MikeFl4
P38A ABS faults and codes
Replies
17
Views
3K
MikeFl4
MikeFl4
R
Brakes
Replies
3
Views
545
andyfreelandy
andyfreelandy