Nevets22002
Active Member
Hi every one.
I had a leak om my transmission and I stupidly steam cleaned it to find out where it was leaking from. This was stupid because now my electrics are all shot to bits.
Iv checked all the connections fuses etc, but I have no wind screen wipers and when I put the hazard lights on they only flash on the passenger side. Also the last dial light doesn't light all the way up and the fuel gauge and volt gauge are both wrong as they both go all the way to the top (read as a full tank when its only half full and volts are past the red) when I switch the ignition on. They like the temperature gauge all worked fine before.
Its been like this for a week now, I thought it might just need to dry out.
This is all on a 1989 110 defender CSW. I'm in Swindon but happy to travel if some one wants a look or please give me some ideas where to start tracing faults.
Please help.
I had a leak om my transmission and I stupidly steam cleaned it to find out where it was leaking from. This was stupid because now my electrics are all shot to bits.
Iv checked all the connections fuses etc, but I have no wind screen wipers and when I put the hazard lights on they only flash on the passenger side. Also the last dial light doesn't light all the way up and the fuel gauge and volt gauge are both wrong as they both go all the way to the top (read as a full tank when its only half full and volts are past the red) when I switch the ignition on. They like the temperature gauge all worked fine before.
Its been like this for a week now, I thought it might just need to dry out.
This is all on a 1989 110 defender CSW. I'm in Swindon but happy to travel if some one wants a look or please give me some ideas where to start tracing faults.
Please help.