CakeBandit
Active Member
Expert advice needed lol!
Trying to fit a autosparks harness and lol not sure how the loom gets routed. No instructions came. The old loom was somewhat custom; fitted ok -a bit patched up from rodents, but I doubt it was correct. Anyways I have a good diagram and I know where 95% of the wires go lol, just not sure what route and the locations of the P-clips should be. (there were no clips, just plastic zip ties, so I bought a few clips)
For instance, the part of the loom that goes to the grill (horn, headlights, turn signals, etc, does it go along the frame, above the frame, but below the battery tray, or the along the top inside of the fender? Do the P-clips go to the mystery holes in the fender? There is a chaffing or a heat protection sleeve on some of that section. Whats that for?
The section that goes down to the dip switch and brake switch, where is the correct locations for the p-clips?
Also surely someone must know, does the ACR type ALT wire on Series 3 vehicles cut across behind the water pump? I saw a picture of a restored 2a (alt conversion) with that wire going that direction with a convenient clip somewhere on one of the bolts there for that too!.
I did search a while for my answer, but all I come up with is loads and loads of diagrams (schematics) not locations. There is a Series 2 picture from a parts book that shows all different kinds of clips, but not the locations. I cant quiet tell from looking a pictures where the wire loom should be routed....
RHD (previuosly POS earth) 2.25 Petrol (Early 2a)
Trying to fit a autosparks harness and lol not sure how the loom gets routed. No instructions came. The old loom was somewhat custom; fitted ok -a bit patched up from rodents, but I doubt it was correct. Anyways I have a good diagram and I know where 95% of the wires go lol, just not sure what route and the locations of the P-clips should be. (there were no clips, just plastic zip ties, so I bought a few clips)
For instance, the part of the loom that goes to the grill (horn, headlights, turn signals, etc, does it go along the frame, above the frame, but below the battery tray, or the along the top inside of the fender? Do the P-clips go to the mystery holes in the fender? There is a chaffing or a heat protection sleeve on some of that section. Whats that for?
The section that goes down to the dip switch and brake switch, where is the correct locations for the p-clips?
Also surely someone must know, does the ACR type ALT wire on Series 3 vehicles cut across behind the water pump? I saw a picture of a restored 2a (alt conversion) with that wire going that direction with a convenient clip somewhere on one of the bolts there for that too!.
I did search a while for my answer, but all I come up with is loads and loads of diagrams (schematics) not locations. There is a Series 2 picture from a parts book that shows all different kinds of clips, but not the locations. I cant quiet tell from looking a pictures where the wire loom should be routed....
RHD (previuosly POS earth) 2.25 Petrol (Early 2a)