thehulkowner

New Member

• May 13, 2007

• #1

Has anybody else got one of these and where have they got there exhausts from if so mines a LWB and im no good at making up exhausts!
pplleeaassee hheellpp

 

Lazy Landy

New Member

• May 13, 2007

• #2

You basicley have two choices, learn to make them, or pay about £500 quid for a custon stainless one.

 

S

slob

Well-Known Member

• May 13, 2007

• #3

bollocks! thurs folk out there that will make a mild steel one fer a lot less. you take the vehicle to them and they make one to fit.
the only one i know of, because its the one i ever needed to use was in glasgow

 

yella

New Member

• May 13, 2007

• #4

or just buy a stock stage 1 exhaust suystem then get a mate that can weld to modify the essex downpipes

 

thehulkowner

New Member

• May 13, 2007

• #5

hmmmmmmmmmmmmmmmm!! i shall! do one of them!

anybody want a bonnet series 2 no wheel holder or a series 3 with chequer platin over wheel holder!

 

choppa

Well-Known Member

• May 13, 2007

• #6

steve parker made the original conversion kit to put those engines in yer motor , and i'm sure they also made an exhaust to fit the same , i could be wrong but its worth a phone call ..

 

thehulkowner

New Member

• May 14, 2007

• #7

yes they do but they are £270 for the whole system i may think about it though!

 

S

slob

Well-Known Member

• May 14, 2007

• #8

i had to make an egghost fer me 111, as it was only the rear bit i needed to do due to fuel tank problems , i went to the garage where me son works and helped meself to some bit of egghost that they had removed and were throwing away.
over here if they have to replace one bit they will replace the whole lot so you end up with a pile of perfectly good egghost pipe destined fer the dump.
with the aid of me grinder avec cutting wheel and me trusty welder i had made me egghost in about half an hour. and it dint look to bed neither.

so if you have a welder a trip to ****-quick might be the order of the day.