Hi guys,
After a bit of advice here.
I have a 300tdi engine/R380 spec discovery with no engine!
I used the engine for another project so am left stuck with a non mover! (Long story!)
I have about the place a 200tdi engine. Is it possible to fit a 200 in its place with out too much fettling?
Do i need new chassis engine mounts or will the 300tdi engine mounts fit a 200?
I plan to use the 300 turbo so hopefully there wont be any exhaust mods. I may have a 200 radiator knocking about also.
I assume the 200 will bolt straight up to the R380.
I realise that this may seem like a step backwards but they seem similar engines and i like a challenge!
I know it probably is just as easy as to jam another 300 straight in but wheres the fun in that!!
Has anyone done anything like this or have any insight?
Thanks.
After a bit of advice here.
I have a 300tdi engine/R380 spec discovery with no engine!
I used the engine for another project so am left stuck with a non mover! (Long story!)
I have about the place a 200tdi engine. Is it possible to fit a 200 in its place with out too much fettling?
Do i need new chassis engine mounts or will the 300tdi engine mounts fit a 200?
I plan to use the 300 turbo so hopefully there wont be any exhaust mods. I may have a 200 radiator knocking about also.
I assume the 200 will bolt straight up to the R380.
I realise that this may seem like a step backwards but they seem similar engines and i like a challenge!
I know it probably is just as easy as to jam another 300 straight in but wheres the fun in that!!
Has anyone done anything like this or have any insight?
Thanks.