H

hamish123

New Member
Hi changed my thermostat a few weeks ago and since then the temp guage sits just on the edge of the white zone and the heaters pump out loads of heat.
It never goes into the red and water is circulating around the system
So presume alls ok.
The stat i took out had failed and the new one is the same temp setting 88 deg C and also flushed and refilled system
Anyone else had this happen on there tdi 200
 
hamish123 said:
Hi changed my thermostat a few weeks ago and since then the temp guage sits just on the edge of the white zone and the heaters pump out loads of heat.
It never goes into the red and water is circulating around the system
So presume alls ok.
The stat i took out had failed and the new one is the same temp setting 88 deg C and also flushed and refilled system
Anyone else had this happen on there tdi 200
Click to expand...

storm99 said:
You fixed it. Want a badge?
Click to expand...

Silly storm, not a badge:rolleyes::rolleyes:, OBE or MBE or Knighthood at least.
 
Hi no its a standard 200tdi 90 the needle was sitting in the middle of the white before and heater was luke warm.as i said it does not gett any hotter once upto temp am rtv this weekend so will see how it goes
 
I repeat.

Its fixed. 200tdis run notoriously cold. Thats why they go on forever.

Will you be happier if it went to the red??
 
Hi to be honest i could not give a toss to you opinion as looking at your post history all you try and do is wind people up.another key board warrior
 
hamish123 said:
Hi to be honest i could not give a toss to you opinion as looking at your post history all you try and do is wind people up.another key board warrior
Click to expand...

I have the same engine in a 1994 disco, and yes it runs allot cooler than you would expect, family members always complain about the heater.
 
Mine sits just below the red when upto temp and my heaters are ****e. Is it worth a thermostat change? I know **** all automotive!
 
guages arent accurate ,often its the differing from normal alerts you to an issue , ensure system is completely full get it to running temp and feel all hoses and all over rad etc,both heater pipes should be hot ,ensure heater cable works fully , if both pipes arent it indicates air lock ,blockage in the marix or low coolant , top hose will stay cold till thermostat opens ,so a slightly warm top hose can indicate thermostat stuck partially open , an adjustable rad muff is useful in cold weather to reduce rad cooling , thermostats often stick slightly open its worth checking and testing new one before fitting
 
Bede said:
Mine sits just below the red when upto temp and my heaters are ****e. Is it worth a thermostat change? I know **** all automotive!
Click to expand...

Thermostat cuts the radiator out of the cooling circuit not the heater matrix. If your temp guage is accurate then you might need a new stat but your heater is probably ****e because the matrix is full of gunk or you have an air lock.

Disconnect it, back flush it, reconnect it and follow the correct bleed proceedure
 
Last edited:
hamish123 said:
Hi changed my thermostat a few weeks ago and since then the temp guage sits just on the edge of the white zone and the heaters pump out loads of heat.
It never goes into the red and water is circulating around the system
So presume alls ok.
The stat i took out had failed and the new one is the same temp setting 88 deg C and also flushed and refilled system
Anyone else had this happen on there tdi 200
Click to expand...
I had exactly that issue with my Defender (200tdi) a tepid heater, I changed the thermostat (old one stuck open) and now it's transformed to a heater worth having.

I had a knock on issue though, straight after the water pump started to leak, I put this down to the increase in pressure in the system, I replaced that and now everything is FAB.
 
hamish123 said:
Hi changed my thermostat a few weeks ago and since then the temp guage sits just on the edge of the white zone and the heaters pump out loads of heat.
It never goes into the red and water is circulating around the system
So presume alls ok.
The stat i took out had failed and the new one is the same temp setting 88 deg C and also flushed and refilled system
Anyone else had this happen on there tdi 200
Click to expand...

what end of the white zone? close to the red or cold end?
 
I thought my temp guage was broken, as since I had it, you can drive any distance and it barely moves off the stop, then last week we hitched 3+ tonnes to the back and booted it up a rather steep hill, so steep it could only be done in first gear as my low box doesnt work, and eventually I noticed the temp guage was just creeping up to halfway, with a radiator muff in place. remove the muff and within a few miles it drops back almost to the stop again.

A mate who has a S2 with a 200tdi conversion says he can drive 30 odd miles, remove the cap from the expansion tank and still put his fingers in the nearly lukewarm water.
 
over last winter i blocked 90% of my disco rad to get it to run at a decent temp, get a thermal probe on the stat housing and see what it reads to be accurate,

cheers steve
 
good info. My truck runs just at the bottom of the red, but right now the Heater core is not plumbed into the loop. I am curious to see what the temp does once the heater is in.
 
You must log in or register to reply here.

Similar threads

Uys
300tdi Conflicting Thermostat Details
Replies
9
Views
873
Stanleysteamer
Stanleysteamer
OscarBoy
300 Tdi Temperature Gauge not working, maybe?
Replies
8
Views
1K
OscarBoy
OscarBoy
farriermatt
Water problems 300tdi in a 1985 110
Replies
10
Views
720
farriermatt
farriermatt
Bustrucket
Disco 2 Td5 Overheating
Replies
3
Views
742
johnlad
johnlad
T
HELP!!! engine overheating - at the end of my tether!
2 3
Replies
52
Views
4K
bendisco
B