jimllshiftit

jimllshiftit

Active Member
My '97 2.5d P38 RR has been becoming more sluggish for the last few months and now its getting too much to bare.

Already I have replaced the intercooler pipes with new silicone ones, the intercooler seems to pumping out plenty of cool air and the turbo fan spins as one would expect. Theres no funny coloured smoke coming out of the back end and its not loosing any oil or water. Brakes don't seem to be binding.

What else could be slowing it down?
 
Anything that controls fuel injection would be my inkling but I'm just a chancer....

Injectors
Pump
temperature sender
maf
map
air filter
timing chain
(in no particular order)

Is the turbo variable geometry? If so whatever controls the pitch.
Other stuff....zorst/cat.
 
Last edited:
myfirstl322 said:
Anything that controls fuel injection would be my inkling but I'm just a chancer....

Injectors
Pump
temperature sender
maf
map
air filter
timing chain
(in no particular order)

Is the turbo variable geometry? If so whatever controls the pitch.
Other stuff....zorst/cat.
Click to expand...

MAF is for EGR it has no effect on running of engine. Look at MAP sensor pipe from below manifold check for splits a make sure it is clear.
 
Just the one mistake, woohoo!

Maf on petrol's governs fuel quantity (I think) but it seems DERV use the info for other purposes.

I'm a layman, but has Maf got to do with Egr?
 
BINGO! Just found the map sensor pipe flapping about in the breeze.

Trouble is, I cant see where it is supposed to be attached. Its still connected at the MAP sensor end but where should it go to?
 
jimllshiftit said:
BINGO! Just found the map sensor pipe flapping about in the breeze.

Trouble is, I cant see where it is supposed to be attached. Its still connected at the MAP sensor end but where should it go to?
Click to expand...
Have a feel/ look under the manifold towards the front of the engine for a nipple.
 
myfirstl322 said:
Just the one mistake, woohoo!

Maf on petrol's governs fuel quantity (I think) but it seems DERV use the info for other purposes.

I'm a layman, but has Maf got to do with Egr?
Click to expand...

On petrol engines the MAF sensor airflow is used for fuelling calcs. On a diesel it is not, it tells the ECU how much exhaust gas is being ingested to regulate combustible air content and reduce Nox production. Plus of course the fact, that this car does not have one.
 
Last edited:
20170711_215726.jpg
 
All of you most helpful and very much appreciated.

Will be interested to know just how much difference this refitting this is going to make.
 
Grrrrrr said:
I put mine back on at the weekend stepped back and then thought: that would have been a good time to do the glowplugs. Doh!
Click to expand...

With a couple of long screwdrivers an extendable magnet a 1/4 drive sockets and uj and adapter to 3/8 ratchet all can be done with the inlet on.

No 2 is a bit of a fiddle past the injection pump but can be done.
 
BLOODY 'EL!!!! This one is like Range Rover GTi or summink! Just repairing that one little pipe and the car now goes like an F'in freight train. Its never been this good in the 6 years ive had it.

Thanks again fellas.........
 
stustrong said:
With a couple of long screwdrivers an extendable magnet a 1/4 drive sockets and uj and adapter to 3/8 ratchet all can be done with the inlet on.

No 2 is a bit of a fiddle past the injection pump but can be done.
Click to expand...

Manifold is a few minutes off and on why struggle?
 
You must log in or register to reply here.

Similar threads

L
P38 2.5 DT Starting Issues
2
Replies
22
Views
2K
Rubberknees
Rubberknees
jimllshiftit
P38a Diesel Grey Smoke and Lacking Power
Replies
10
Views
824
N2O
N
N
Defender performance issues
Replies
5
Views
1K
Nerdos
N
R
P38 - How Much?
2
Replies
33
Views
5K
RR Driver
R
ONE LIFE LIVE IT. D90
300tdi no power/grunt? Another thread i know
2
Replies
30
Views
4K
IamRobbie
IamRobbie