snifferg
Member
Hi all, appreciate some advice on my 2.0DI manual.
Basically it jumps out of reverse - it started off doing it only occasionally but now most of time accompanied by much crunching when you try and get it back in.
When it first started doing it you could get around it by switching off the engine, selecting reverse and then turning it back on but it seems to slip out when this method is used now too.
All forward gears work seem to work perfectly. The clutch was replaced last summer and I had hoped this would fix it (it was intermittent then) but no such luck.
I'd appreciate any pointers - is the gearbox basically U/S or is there anything else I can check before considering this expensive replacement? If the gearbox does require replacing any ideas how long it would take? (garage hours I mean).
Thanks in anticipation.
Jonathan
Basically it jumps out of reverse - it started off doing it only occasionally but now most of time accompanied by much crunching when you try and get it back in.
When it first started doing it you could get around it by switching off the engine, selecting reverse and then turning it back on but it seems to slip out when this method is used now too.
All forward gears work seem to work perfectly. The clutch was replaced last summer and I had hoped this would fix it (it was intermittent then) but no such luck.
I'd appreciate any pointers - is the gearbox basically U/S or is there anything else I can check before considering this expensive replacement? If the gearbox does require replacing any ideas how long it would take? (garage hours I mean).
Thanks in anticipation.
Jonathan