R

R G

Guest

• Nov 19, 2005

• #1

it will not disengage is it the bearing or the presher plat.....there is
no racket....out or in....be for it went out the bearing made some when
cold....

 

C

Coasty

Guest

• Nov 19, 2005

• #2

It it uses a clutch cable it may be broke.

--
Coasty

Remove the SPOOGE to reply
"R G" <thewagonburner@webtv.net> wrote in message
news:20592-437E7B4C-120@storefull-3274.bay.webtv.net...
> it will not disengage is it the bearing or the presher plat.....there is
> no racket....out or in....be for it went out the bearing made some when
> cold....
>

 

R

R G

Guest

• Nov 19, 2005

• #3

its all linkage...how bout the fork...do you think the bearing slipped
off

 

C

Coasty

Guest

• Nov 19, 2005

• #4

It could be several things, the fork could be bad where it connects to the
linkage or the clutch is just plain wore, the pressure plate fingers are
gone, at this point the tranny needs to be pulled you can't fixit by
diagnosing it fro the outside.

--
Coasty

Remove the SPOOGE to reply
"R G" <thewagonburner@webtv.net> wrote in message
news:1180-437F0D9C-620@storefull-3272.bay.webtv.net...
> its all linkage...how bout the fork...do you think the bearing slipped
> off
>