Replacing an A frame ball joint
- Thread starter andy vash
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
apply pressure to the top of the joint with a lever or jack,if worst comes to the worst nut will split easy with a decent hammer and chisel
- Posts
- 11,023
- Location
- North of the Wall
Angle grinder.
Roaming Wombat
Well-Known Member
- Posts
- 424
- Location
- Fortress Europa
What jamesmartin and Al203 said; you're replacing the part and nut so no need to faff about, pick your weapon and go to town on it.
Us civillised folk use nut splitters, rather than the yobbos wi' there hammers and noisy cutting things
Us civillised folk use nut splitters, rather than the yobbos wi' there hammers and noisy cutting things
discool
Well-Known Member
- Posts
- 13,609
Get someone else to do it
- Posts
- 11,023
- Location
- North of the Wall
Aye, but you're posh doon Sooth though!What jamesmartin and Al203 said; you're replacing the part and nut so no need to faff about, pick your weapon and go to town on it.
Us civillised folk use nut splitters, rather than the yobbos wi' there hammers and noisy cutting things
Marmaduke
Well-Known Member
- Posts
- 9,773
- Location
- Near the land of 'Me Duck'
I've drilled a series of holes in the nut when I've done it before then give it some with a bolster chisel
