Hope someone could shed some light on this for me as its getting a right pain in the behind, had problems with rangey not starting, when i pulled and pushed relays in and out it seemed to come to life, i have now traced it to relay 19 which on here P38 Range Rover Engine Bay Fuse Box Fuse and Relay Information-P38 Range Rover Electrical Common faults and Fixes it says Engine Main Control Relay, what happens now is sometimes it starts fine and other times i get no glow plug light on dash and no noise of any pumps etc from engine bay, if i then pull said fuse in and out or put a test light from earth on battery to outside edge prong on relay 19 it lights up the test light then when i pull relay out and back in the test light goes off and glow plug light comes on and hear pumps start in engine bay and will then fire up, hope someone can understand this help, cheers guys
P38 Relay 19 problem
- Thread starter gooner49
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
dougdotcom
Active Member
- Posts
- 605
- Location
- Langley Mill. Nottingham
sounds like its burnt under the fusebox where the relay slots in and damaged a wire. remove the fusebox and check under where the relay slots in. 
roddy4
New Member
- Posts
- 664
- Location
- banbury,oxfordshire
they suffer with the fusebox should of bought a new one for peace of mind,did you refit the same relay?
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
Fuse box and/or relay.
Ryan Williams
New Member
- Posts
- 3
- Location
- South Wales
Hello did you ever fix this issue? I have the same problem.
Rick-the-Pick
Active Member
- Posts
- 782
- Location
- Hove, Sussex.
It could be a dodgy glowplug earthing out on the engine.
Ryan Williams
New Member
- Posts
- 3
- Location
- South Wales
I've narrowed my fault to the car down to these relays. I've ordered some replacement relays, but i'm not sure if there is a fault with the fuse box itself. There seems to be some mods to the fuse box which improves the power supply to the car. http://rangeroverworld.blogspot.co.uk/2010/02/fuse-box-relays.html
dubbleRR
Well-Known Member
- Posts
- 1,018
- Location
- highlands of Scotland
You could try bending the relay legs (,just a little) but not so much you have to force the relay in O and look for heat cracks on the relay pin socket or a smell like burning,...
O and look for heat cracks on the relay pin socket or a smell like burning,...Ryan Williams
New Member
- Posts
- 3
- Location
- South Wales
