Hi folks.
My Td6 has just decided to play dead in the suspension department.
It had previous problems where it would flash up the Inactive Suspension message now and then. I had it looked at by the local dealer who updated the software and it has never missed a beat since. That was a good few K ago, back in June.
At the weekend it decided to leave the back at a low setting and jack the front in the air. There are no lights on at the switch/Led panel and nothing I do changes it.
I can hear a click, click coming from under/in front of the spare wheel at times. It sometimes stops and starts again.
Like I said, I have had this problem before, but it normally goes away and when the fault is present, I have the LED lights on the console and also the inhibit LED in the centre of the switch would light.
Not this time!!!!
So, before I head to the dealers again, are there any ideas of what I could look for??
The compressor is not running, the fuses are okay(one in glove box and one in the boot)
Should I remove the valve block and get the repair seal kit for it and see if that helps. Its like there is a balance valve stuck and its not letting it equalise.
The other thought was the pressure switch.
Has anyone removed this before?? Whats the best options for removal??
SO many questions, I know, however, I am wanting to cure this once and for all.
Regards
Jamie
My Td6 has just decided to play dead in the suspension department.
It had previous problems where it would flash up the Inactive Suspension message now and then. I had it looked at by the local dealer who updated the software and it has never missed a beat since. That was a good few K ago, back in June.
At the weekend it decided to leave the back at a low setting and jack the front in the air. There are no lights on at the switch/Led panel and nothing I do changes it.
I can hear a click, click coming from under/in front of the spare wheel at times. It sometimes stops and starts again.
Like I said, I have had this problem before, but it normally goes away and when the fault is present, I have the LED lights on the console and also the inhibit LED in the centre of the switch would light.
Not this time!!!!
So, before I head to the dealers again, are there any ideas of what I could look for??
The compressor is not running, the fuses are okay(one in glove box and one in the boot)
Should I remove the valve block and get the repair seal kit for it and see if that helps. Its like there is a balance valve stuck and its not letting it equalise.
The other thought was the pressure switch.
Has anyone removed this before?? Whats the best options for removal??
SO many questions, I know, however, I am wanting to cure this once and for all.
Regards
Jamie
