Extra Gauge Pods

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Al2O3

Al2O3

Well-Known Member
Full Member
Posts
11,023
Location
North of the Wall
I'm thinking about putting two gauges in and was hoping to get a pod for them to clip in the ash tray on top of the dash. Raptor do one but it is for four gauges. I've looked at Mud Stuff and Croytec, but they are screw in to dash ones and I don't want to put holes in the dash. Are there any other makes out there? Cheers.
 
Im sure the mud stuff one has a plate that goes under the dash. I have one which I havent fitted, I can check when Im home tomorrow
 
Disco1BFG said:
Well, I bought one of these..

www.ebay.co.uk/itm/221741409218

which is a three gauge pod, and they used to do a two gauge one, but not right now :(:rolleyes: ( out of stock ? )

You'll just have to fit another gauge :D
Click to expand...
You'd have to drill holes through the top of the dash with that one I guess?
Hmmm.......... a third gauge :)

gazman said:
Im sure the mud stuff one has a plate that goes under the dash. I have one which I havent fitted, I can check when Im home tomorrow
Click to expand...
Cheers, but I think that'll mean drilling holes too. Looks like Raptor are the only ones who have designed something to clamp in the ashtray hole.
 
Al2O3 said:
I mean to screw the pod to the dash, not to get the cables in.
Click to expand...

Mine is held on with double sided tape - no dash board were harmed in my installation :D

And I haven't got any pics from the time, but I'll go and take some now.....
 
Al2O3 said:
Sounds great. Cheers. :D
Click to expand...

So, here's a general piccie of the "pod" on me dash - me wires and pipe go through the holes in the vent beneath the pod. I made a bit of 9mm ply fit the underside of the pod, and then used M4 socket heads to hold the ply to the pod... then.... the ply and thus the pod are held to the dash with halfrauds double sided number plate tape - its been there 2 years, and it ain't loose yet - but brake cleaner will fetch the glue off, should the need arise.....

20170610_174633.jpg

And, just for completeness, and your delectation..... here's a close up of the base of the unit - with super magnification, you should just be able to see the ply, and the double sided tape

20170610_174538.jpg


Works for me ! :)
 
You must log in or register to reply here.

Similar threads

D
TD5 fuel gauge not working
Replies
0
Views
285
Dandyservices
D
A
Fuel gauge and fuel light issue
Replies
4
Views
310
Acdadefender1
A
K
What money should I be asking?
2
Replies
27
Views
4K
Karls
K
S
voltage stabiliser
Replies
1
Views
366
Tall Ratbag
T
OscarBoy
300 Tdi Temperature Gauge not working, maybe?
Replies
8
Views
1K
OscarBoy
OscarBoy
Back
Top