Chrisw8
Well-Known Member
- Posts
- 1,980
- Location
- Top of the Hill
To fit them they will need to be at a different angle to the originals and another hole drilled nearer the back.
Any thoughts?
Disco 1 rear mud flap bracket supports
- Thread starter Chrisw8
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
To fit them they will need to be at a different angle to the originals and another hole drilled nearer the back.
Any thoughts?
discool
Well-Known Member
- Posts
- 13,608
So what VIN number did u use wnen you ordered them?, there a two stays available and depending on VIN as u have now found out.
Assume u have a 300 series D1 with VIN from KA 038265 the part number of the staysu require is BTR6172, no doubt obsolete by now, so your left with Britpart with what u have with the additional hole.
Not difficult to modify, if you can’t be bothered to send them back.
Assume u have a 300 series D1 with VIN from KA 038265 the part number of the staysu require is BTR6172, no doubt obsolete by now, so your left with Britpart with what u have with the additional hole.
Not difficult to modify, if you can’t be bothered to send them back.
Chrisw8
Well-Known Member
- Posts
- 1,980
- Location
- Top of the Hill
I just looked on YRM.
They do galvanised ones in the shape I need.
They do galvanised ones in the shape I need.
discool
Well-Known Member
- Posts
- 13,608
That’s where I’d go, and include the bracket, but years away from doing that
Similar threads
