socket and a big breaker bar jammed onto the chassis and a very quick flick of the starter is the normal method
300tdi snapped cam belt
- Thread starter Series71
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
socket and a big breaker bar jammed onto the chassis and a very quick flick of the starter is the normal method
- Posts
- 83,296
- Location
- Embasinga stocæ
hang on Sean - dint he say he has the bolt off - so a hub puller shud just pull the pulley straight orf.
sean needs to go to specsavers
- Posts
- 83,296
- Location
- Embasinga stocæ
yu do yuze a wading plug - dont ya?
- Posts
- 83,296
- Location
- Embasinga stocæ
well.....
if yu duz - and it still looked like tha - we all autta be worrited.
if yu dont - i think yu might be in future.
just think wot the inside of ya bellhousing looks like?
mite be worth taking off the starter motor and having a shufty inside??
if yu duz - and it still looked like tha - we all autta be worrited.
if yu dont - i think yu might be in future.
just think wot the inside of ya bellhousing looks like?
mite be worth taking off the starter motor and having a shufty inside??
discomania
Well-Known Member
- Posts
- 6,947
I would take all the pulleys off, clean the lot. If you were not planning on replacing the idler and tensioner pulley then make sure you do that too.
ratty
I'm not special I'm limited edition
- Posts
- 34,277
From what I gather he's rather enthusiastic when ity comes to mud plugging.
From what I gather he's rather enthusiastic when ity comes to mud plugging.
Sure, and we all applaud his efforts to get the OUTSIDES of his Landy all pretty and muddy (that being what Landy paint is for) but someone needs to tell him it is NOT necessary to fill the INSIDES of his engine with mud.
I still want to know what's in the bellhousing!
CharlesY
- Posts
- 83,296
- Location
- Embasinga stocæ
- Posts
- 83,296
- Location
- Embasinga stocæ
sorry Uncle CharlesY - i have added to my post several times.
A good tip here is to remove the rocker gear complete, most discos bend all push rods or bend rocker arms, very rarely any engine damage...take out glow plugs and do a compression test on cyl,s...if OK then carefully examine rocker arms for damage even stress cracks will fail eventually so look with a mag glass ...you must replace all push rods (as has been suggested)...if the comp test fails you are in trouble but done thro the plug holes saves you taking injector gear off...best of luck..
