THEengineer
whatever
- Posts
- 4,978
- Location
- near big mountains and lots of mud
whats the difference between 3 hole and no hole? does it refer to gasket thickness?
300 tdi gasket set
- Thread starter THEengineer
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
blue beasty
Leaks an prone to bits dropping off
- Posts
- 62,972
- Location
- Gloucestercotshirewolds
Yes. I believe thinnest to thickest goes 1 hole, 2 hole, 3 hole, no hole.
Somebody will confirm or correct hopefully
Somebody will confirm or correct hopefully
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
1 hole is 1.3mm 2 hole 1.4 mm 3 hole 1.5 mm,0 hole 1.6mm
THEengineer
whatever
- Posts
- 4,978
- Location
- near big mountains and lots of mud
cheers james as always,i am using a second hand head,can i check its not warped with a steel rule or is it better to get it skimmed,valve guides done and use the thicker gasket,its a international engines south america head,so could be off a late 300 tdi
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
its allways best not to skim if possible but warping or damage from fire ring may mean you have too, in theory you fit same gasket as was fitted as piston height dictates, but skimming head moves valve nearer the head surface so people use the next gasket up to cater for that ,so if you skim, place flat edge over head and measure gap between valve head and face with feeler gauge ,inlets must have a gap of at least 31 thou and exhaust 33 thou
THEengineer
whatever
- Posts
- 4,978
- Location
- near big mountains and lots of mud
brilliant James best advice as always,will check this first
Similar threads
